Posted on 09 March 2013 20:49
2006 Evinrude E-Tec 250 HP 25 Inch Outboard Motor SPARES OR REPAIR
- SUBMERGED IN FRESH WATER AND SIEZED BUT OIL AND DIESEL APPLIED TO INTERNALS BEFORE STORED
- COMPLETE ENGINE
- HYDRAULICS GOOD
- GOOD PROP AND LOWER GEAR BOX
- MANY GOOD PPARTS
- NO CORRIOSION AT ALL
- SOME SCUFFS AND LID CATCH DAMAGED NO TIME TO REPAIR
NOW EVEN MORE HORSES. AND ALL THEY WANT TO DO IS RUN.
Bigger engines. Bigger lead. More displacement, more torque, more top-end than anything in the V-6 class. Too much of a good thing? Not when you’re this good.
Enginetype V6 90° E-TEC DI Displacement 200 cu in/3279 cc Recommended fuel 87 Octane Emissions compliance CARB 3 Star, U.S EPA, European Union Recommended Oil Evinrude/Johnson XD100™ OilPropshaft HP 250 HP (187 kw) @ 5150 RPM Full Throttle RPM Range 4500-5800 tr/min Alternator output 133 Amps Total Output/ 50 Amps Net Dedicated Fuel induction E-TEC DI w/ Stratified low RPM combustion mode Lubrication Multi-point, targeted oiling Bore x Stroke 3.854 x 2.858 in / 98 x 73 mm
|
|
Posted on 09 March 2013 20:43
SMALL 8.5 ft GO CART LIKE SPEEDBOAT WITH 40 hp OUTBOARD
COMES WITH TRAILER AND 40hp OUTBOARD ENGINE,
ENGINE KNOWN TO BE NISSAN. NO TILTS AND TRIM,
ENGINE IS PULL START AND COMES FULLY FUNCTIONAL WITH STEERING AND FOOT THROTTLE , ALSO HAS EMERGANCE RIST BAND CUT OUT ,
GOES VERY WELL INFACT GOES AWSOME .
FOR YOUNG OR OLDER CHILDREN BY THAT I MEAN ADULTS TOO HAHAH LOTS OF FUN TO BE HAD NO MATTER YOUR AGES.
VERY LIGHT AND EASY TO HANDLE ON BEACHES OR SLIP WAYS . GREAT TOY FOR EVERY ONE AND WONT TAKE MUCH ROOM IN YOUR GARAGE .
PICK UP IN PERSON ONLY
|
|
Wayne IVSS MARINE: Posted on 09 March 2013 20:35
RECONDITIONED VOLVO PENTA DPC / DPE STERNDRIVE INSTOCK NOW
Ready to take !!DRIVE COMES COMPLETE WITH - OIL
- HOOK UP BUSHES
- ANODES
- PROP CONE AND SPACERS
- 1.95:1 RatioVOLVO PENTA DP-C MODEL FITS DPE SET UPS ALSO AND IS MORE OR LESS THE SAME DRIVE. OFFERED WITH OR WITHOUT EXCHANGE
- WITHOUT EXCHANGE £2250 NO VAT
- WITH EXCHANGE £1750 NO VAT
PLEASE CALL FOR FURTHER DETAILS:
07890659931
|
|
Wayne IVSS MARINE : Posted on 09 March 2013 18:38
FAST FISHING BOAT AND TRAILER, WITH OR WITHOUT REBUILT JOHNSON 175 HP V6 OUTBOARD- Nearly finished fast fishing boat
- Will idealy fish 2 / 3 people
- Nice stand up cabin with lots of room
- Lots of New items fitted such as VHF & AREIAL , FISH FINDER, ROD HOLDERS, BATTERY AND BATTERY BOX, NAV LIGHTS, INTERIER LIGHTS, DECK LIGHTS etc....
- Nice tidy boat for easy launch on either slip ways or beach
- Has done 60 mph with a JOHNSON 200 V6 and performed great,
- Fished 3-4 people on nice summer days,
- Foam filled hull with inspection hatches
- Optional with or with out engine, but this AUCTION is for boat and trailer WITHOUT ENGINE.
MUST RECIEVE CLEARED FUNDS BEFORE BOAT CAN BE TAKEN DEPOSIT NEEDED WITHIN 2 Days PURCHASE THROUGH THIS AUCTION Call for more information 07890659931
|
|
Posted on 01 September 2012 21:38
Boat engine
SECOND HAND GOOD RUNNING 6 CYLINDER TURBO DIESEL MARINE ENGINE
VERY TIDY CLEAN ENGINE JUST SERVICED AND PAINTED.
READY AND CONVERTED TO FIT THE VOLVO PENTA 270, 280, 290, DPE .STERNDRIVE .
COMES WITH BELL- HOUSING ALL ANCILLARIES AND WIRING HARNESS, THROUGH BOAT LOOM AND DASH PANEL
in-board diesel engine 100 - 200 hp (direct injection, turbocharged) D150 (135 HP @ 3800 rpm) The BMW D150W Marine Engine 100kW(136bhp).Particularly suitable for displacement boats and fast planing cruisers Through its compact dimensions and extremely low weight:60 kg/132 lb less than most of its competitors.
FOR MORE INFO AND CONTACT DETAILS PLEASE CLICK ON THE PHOTO..
|
|
Posted on 22 June 2012 14:59
Second hand spares / repaire jet bikefor sale. This ski was last used last year 2011 when towards the end of the summer one of the rings let go and caused some minor damage.
She will need a full gasket kit, piston and rings and away you will go again.
She was working great fro years , very reliable and gave great fun for all. And not bad on fuel either.
The engine was removed for inspection then with winter approching and far to busy at work the poor ski sat waiting. Cosmetics are taty from alot of use , but with a polish and new foam feet pads ,she will look fine.
The hull is sound no leaks and was always beached on sand.
The trailer works fine but could do with a winch and new wheel bearings. Nothing unusual there...
We paid £1500 for this ski just beggining of last year, so grab a bargin and have this lovelty cheap project ski and get the urg for the water cured.
The engine and bay is very clean with very very little oxidisation.
07890659931
|
|
Posted on 31 January 2012 11:07
Volvo Penta Inboard AQ130 Reconditioned Boat Engine and Stern-drive Package.
This engine was fully-reconditioned this year everything was rebuilt renewed and repainted replaced as necessary.
You may notice (thanks sinbad1405) the Solex carbs have been replaced by the older Stromberg's. This allows for tighter fitting under the engine cover and in my opinion offer better response. The engine is as good as new as can be seen in the picturesI had it done by a professional and specialist in marine engines I.V.S.S MARINE.
Unfortunately the boat I was planning to put it in is going to remain an unfinished project.This means I am selling the Engine (as listed), and the Sterndrive 280 leg (not included) and the Trailer (not included) that the boat is sitting on, as I no longer have the time or interest to finish the project. (would consider an offer for the lot)
Collection only from Lydd Kent(Would consider delivering at a cost to you.)Cash on collection
Tel. 07841238322
|
|
ivssmarine.wavepower.org.uk: Posted on 14 November 2011 22:25
Completely stripped and rebuilt, removing & replacing any defective
components or parts that have worn beyond manufacturers specifications.
When we say "completely stripped" we mean everything including stripping
fuel pump, distributor, alternator, carburetors, raw water pump, oil
cooler, & exhaust manifold. You will find it difficult to find this
quality of rebuild at such a keen price.
All exterior components/parts dipped to remove paint & rust, &
then repainted .
Rewired to the original Volvo wire colours & sizes (including the 11
pin plug, and an additional socket & connectors are also enclosed
for convenience)
Run and analysed on custom engine test stand.
Typically Includes:-
- Skimmed cylinder head.
- Valve seats recut & lapped.
- Honed cylinder bores.
- Complete gasket sets & filters.
-
New impeller, alternator belt & oil pressure sender.
-
New Exhaust Manifold & Elbow.
-
New top copper pipework for cooling circuit.
Tests:-
- Cylinder Compression.
-
Oil pressure.
-
Water temp & circulation.
-
Ignition & Charging circuit.
Only the bell housing not included. All components to make up a complete
engine are included in this auction.
Also complete system (i.e. including outdrive) available to order.
Exchange welcome, rates are dependent on condition of your engine.
Other Engines in stock & available to order. (i.e. AQ130, AQ171,
AQ205)
Based in New Romney Kent, UK
Franchise of IVSS Marine (http://ivssmarine.wavepower.org.uk)
LOCATION: NEW ROMNEY, KENT PRICE: £2500 Any questions: 07890 659 931
|
|
Posted on 24 October 2011 18:42
fanless pc, built for the marine industry Maxsea v12Piscatus v5120gb hard drive,2gb ram,windows xp royale 12 volt/24 volt/240 volt1 years RTB warranty - RoHS Compliant 1.8GHz Intel Atom D525 processor and Intel GMA 3150 video.
- Intel NM10 Express Platform Controller Hub Chipset..
- Realtek RTL8111E 1000Base-T Gigabit Ethernet and High Definition
- Realtek ALC888 Audio.
- Rear Panel:PS2 mouse and keyboard
- VGA4x USB ports1000 Base-T EthernetSerial (COM) PortParallel Port, 3.5mm Line in, Line out & Mic in connectors.
maxsea and piscatus software already installed, you will not find these cheaper anywhere else and remember these are built to order and also brand new components,they are fast and reliable and no psu fan to draw in the damp air,lots of buyers very happy,ring or email me for a chat. LOCATION : EASTBOURNE PRICE: £400 Graham 07733453826
|
|
Posted on 24 October 2011 17:49
27 ft RENEKEN FOR SALE Huge American fishing cruiser, needs a good polish and tidy up but is on the key and ready to fish . she is Four berths with galley/seating area, shower and toilet. Comes with a Honda FOUR STROKE 225 hp , great powerful engine, Fishfinder and VHF. Has recently fittet new cover, also captin and passanger seats. Loads of fishing space length and beem. would say about 9 ft possiable 10 ft beem . LOCATION : NEW ROMNEY, KENT PRICE: £15,500 ono Call Wayne on Tel: 07890659931
|
|
Posted on 24 October 2011 17:22
DORY 17 PROJECT
Here i am selling a dory 17ft project boat, ideal for a weekend fishing boat . Will take anything up to a 75 hp outboard. It is hull only with removable cab so you can have an open day boat on the summer days. She is a very safe going boat , heavily built with twin skin hull, and wash decks . Steering is in already fitted but unsure of condition and will need a steering wheel £11 from NAUTE QUIPE. she has some repairable damage on upper skin . there is no trailer or engine , comes with plenty of storage compartments Vewing is welcome .
LOCATION : NEWCHURCH, KENT
PRICE: £750 ono
PLEAS CALL LES ON TEL: 07967468649
|
|
Posted on 13 September 2011 00:14
FOR SALE .
MANY AVALIABLE , DRIVES COME FULLY RE-FRESHED. INCLUDING :
- SAND BLASTED
- FULL STRIP AND FLUSH
- PARTS CHECK
- ALL DAMAGED PARTS REPLACED FOR GOOD OR NEW
- ALL CONSUABLES SUCH AS BUSHING REPLACED FOR NEW
- RESHIMMED
- ASSEMBLED WITH GREAT CARE
- NEW U.J CROSS-MEMBER BEARINGS
- ETCH PRIMED
- TOP-COATED WITH HIGH STRENGTH TWO BACK
- FINISHED WITH TWO PACK HIGH STRENGTH LAQUER
- PRESSURE TESTED
- FILLED TO CORRECT LEVEL WITH OIL
- HOOK UP BUSHES
- ANODES
PRICE ....£1100 Exchange
TEL: 07890659931
|
|